Quick Answer: Do I Need Expensive Speaker Cables?

What happens if speaker wires touch?

Well it all depends on which of the wires touched, and how the amp is designed.

Usually the result of speaker wires touching (shorting out) is a dead amp channel.

Though if say the right channel + touched the left channel – it might do nothing.

Or blow up the amp..

Does speaker wire get old?

It’s the oxidation (corrosion) that is going to cause degradation, not age per se. Copper wire can oxidize in a matter of months, or it could take years. So, it would be unfair to say “old” speaker wire is bad. Corroded speaker wire can be bad.

Do speaker cables really make a difference?

Of course, cables do make a difference, but the reason for the difference is not their exotic structure or the choice of an exotic material. The only difference what people can hear is caused by the resistance of the cable.

Are expensive speaker wires worth it?

An expensive cable might sound worse on your system than cheap cable. Or it might sound better. The important thing to remember is that even if it does sound better, it’s such a minuscule improvement that pretty much anything else you can do will have a greater effect on the sound.

Are speaker cables important?

Speaker cable is the wire used for the electrical connections between speakers and amplifier sources. It has three key electrical properties: resistance, capacitance and inductance. … Low-resistance wire allows more of the source’s power through to the speaker coil, meaning more power and more sound.

Does speaker wire affect sound quality?

Quick answers: Does speaker wire affect sound quality? Under normal circumstances, the answer is NO: speaker wire does not affect sound quality. However, in some cases, (explained in further below) sound quality or volume can be affected somewhat.

What happens if speaker wire is too thin?

Your receiver is heating up due to the ac impedance being too small, this causes the current in the wires to go up. But the “smaller” wires results in more resistance. (so, with more resistance, you get less current). But, if you have frayed wires, and they are bridging the terminals, then this will cause overloading.

How long can you run an AUX cable?

Audio Mini Jack: With 3.5mm audio, Cable Chick stocks a maximum length of 10 metres. Why? Because 3.5mm cables are most commonly used for personal headphones where any dips in audio quality become very apparent.

Are Monster audio cables worth it?

Monster cables and higher-end cables have been around for a few years. The marketing for these high end cables seem to indicate you’ll get better audio from your speakers by buying these pricey items. In fact, these very expensive cables don’t make a significant difference. … In fact, high end cables can cause problems.

Is optical audio better than HDMI?

Both can pass multi-channel audio, like Dolby Digital. Both cables can be had pretty cheap. The biggest difference is that HDMI can pass higher-resolution audio, including the formats found on Blu-ray: Dolby TrueHD and DTS HD Master Audio. These formats can’t get transmitted across optical.

What speaker cables do I need?

Thick wire (12 or 14 gauge) is recommended for long wire runs, high power applications, and low-impedance speakers (4 or 6 ohms). For relatively short runs (less than 50 feet) to 8 ohm speakers, 16 gauge wire will usually do just fine.

Do expensive aux cables make a difference?

At the normal 3–6 ft for an aux cable, there will be no AUDIO differences that the human ear can pick up. However, there will be DURABILITY differences. This is a much bigger selling point, or it should be, than trying to determine sonic differences between two 4ft cables.

Can I use electrical wire for speakers?

To answer the question posed at the start of this article – yes, you can use a regular electric wire as a speaker cable, as long as it comes with two same-sized conductor wires.

What is the best speaker cable to buy?

Best speaker cables 2020: budget and premium audio cablesAudioQuest Rocket 11. A sensational speaker cable and 2019 What Hi-Fi? … Chord Company C-Screen. A brilliant budget option if your system needs an upgrade. … QED Reference XT40i. … Atlas Equator 2.0 (2018) … Chord Company RumourX. … AudioQuest Rocket 22. … QED XT25. … Van den Hul The Clearwater.

Is Aux better than Bluetooth?

Bluetooth relies on very heavy compression which significantly compromises audio quality. AUX uses analog audio and can deliver full fidelity reproduction. … Generally speaking, audio quality is better through an Aux cable than over BT.

Is thicker speaker wire better?

Thicker wires are better: It’s true that for long runs, thicker wires are better at reducing the effects of resistance. But for most set ups (those with speakers within 100 ft of the amplifier), 16-gauge lamp cord is fine. For speakers 100 to 200 ft. from the amp, experts suggest use 14 gauge.

Is 18 gauge wire OK for speakers?

All speakers work best with the largest gauge wire possible, 18 being the “standard”. … The manual states that up to 20 ft an 18 gauge wire is fine with 16 and 14 gauge for longer runs.

What happens if wire gauge is too big?

using larger wire will not hurt anything or cause any overload. The larger wire will cost more, the pathway or where it has to fit, and the physical size of the connecting means (ie. the size of terminal or clamp it has to fit in), will all be determining factors in just how big is too big.

Are aux cords better than others?

So to sum things up, yes, some “AUX” cords are better than others, but if you buy one that is not too long and is from a brand people have heard of, they are all pretty similar. That is, unless you are buying cables for high-end audio equipment, then this is beyond the scope of this answer.